How to Change a Subaru Spare Key

If you lose your Subaru car key, you should call a locksmith. They can usually cut keys for you at a lower cost than the dealer.

Fob remote "push to start" intelligent keys or a basic metal key are the two most commonly used kinds of subaru key copy car keys. The Fob key has to have its chip changed.

Keyless Entry System

A key fob lets you to lock or unlock your subaru transponder key from a distance. It could even unlock the trunk or lift gate of your vehicle. These remotes make use of the keypad of your car to communicate with your vehicle's computer.

Certain models of Subaru offer a little-known feature called PIN Code Access. You can choose a personal number sequence to open and start your car. Read the owner's manual to learn how to program subaru key to use this feature if you have a Subaru Forester, Outback Crosstrek, WRX STI or Impreza.

If your keys stop working, there's a high chance that the battery in the key fob is dying. You can test the battery life of your key fob by using a portable tester or a multimeter that you have in your garage.

The next step is to take the key fob out of its case, and then examine its transmitter circuit board. You'll be able where To Get a subaru key made see two or three sets of 8-digits. Note down the first set so that you can recall it. After you've done this you can begin programming your key fob at home. The procedure for programming varies depending on the model and year of your vehicle, but it's usually simple enough to complete on your own.

Key Fobs

Subaru's latest models all feature key fobs that not only unlock the doors but also activate your lights, lock your gas cap, and even start your car. This is especially helpful if you've found yourself at the gas station and your car wouldn't even start because the battery in the key fob has died.

It's likely that your Subaru's key fob, regardless of whether it's new or old and can be replaced. Be aware that some most modern models, with their high level technology, might require a visit to the dealer. But, with a bit of time and effort, you can find a replacement key fob in place at home.

Begin by looking at the circuit board for the transmitter inside your key fob (instructions for opening the case are provided in your owner's handbook). It should contain one or two serial numbers, each of which has 8 digits long. Write down the number that is the first in the series and keep it in a safe place to refer to in the future.

Then, you'll need to get into the driver's seat, and close all of the doors. Turn the key ten times to start your car, and then turn off. Press the lock button on your key fob and open the door to check whether your doors are functioning properly. Close the door, and then remove the key. You should hear your vehicle beep again, indicating that the key fob has been programmed.

Ignition System

The key battery could be dead if your Subaru keys aren't working as they should. You can replace the battery for your key fob on your own if you know how. A replacement battery is inexpensive and is fairly easy to locate. If the key fob isn't responding to your commands it could be a different problem. To obtain a spare key, it's advisable to go to a dealer. They'll guarantee that the key is a genuine Subaru key that's under warranty and will be programmed to your vehicle. This is much simpler and safer than purchasing an aftermarket one from a company online.

The dealer can also cut a key for you if you provide your VIN number and as evidence of ownership. They'll use this information to program the replacement key so that it can be accepted by your immobilizer. This is a much more complicated procedure than cutting a single key, and the dealer will charge you more.

Once the new key is programmed and you're able to change it over to your existing key. It will only take you five seconds to insert the new key, so keep your working key close at your side. When the security light ceases to flash and you're able to remove the new key and examine it to make sure that it's functioning correctly.

Battery Replacement

subaru keys replacements fobs are very useful because they can turn on the power windows and sunroofs of your car with just a single button press. The battery in your Subaru fob isn't built to last forever, and it will require replacement at some point. This short guide from Capitol Subaru will help you to replace the battery yourself.

To begin you'll need to find the small crevice within the seam that separates the back and front of your key fob. It is possible to open this seam with a flathead screwdriver to reveal the small compartment that contains the battery. Insert the new battery and make sure it is facing up correctly. Remove the old one. After you have put everything together you can use the new key fob to lock, unlocking, and starting your vehicle.

It's always best to have an additional set of keys on hand, especially if you've lost yours or it's not working properly. A new key can be bought at your local auto dealer, or you can have one cut by a locksmith. It is important to ensure that your key fob functions well as soon as possible so that you can drive safely.